Skip to Main Content
Created by Oto Lukss
Created on May 31, 2021

Option to clone reconstruction

Need an option to clone reconstruction. Like one reconstruction as-is and then copy this reconstruction for retouch to remove unwanted objects. Now if reconstruction is copied it doesn't clone reference model and need to regenerate all again to get reference model for retouch.

  • Scott Ernst
    Reply
    |
    Oct 12, 2021

    I was just wishing for the same thing the other day. In my case I had a difficult reconstruction that took 22 hours to process and had quite a few artifacts that I had to clean. The site had a lot of trees against the facades of the historic structure that I was documenting. I wanted the trees for the orthophoto of the site, but then I wanted to remove the trees for orthos of the facades, but I didn't want to have to clean all of what I had already cleaned as well as the trees and then have to do another 22 hour production.

  • Oto Lukss
    Reply
    |
    Jun 1, 2021

    No, it is not just in case, it is valid workflow as need to have two 3d mesh as result one is Reality mesh of city block as-is and other is Reality mesh as planned after demolition of building or ground leveling. Aerotriangulation is cloned but reconstruction is not actually a clone it is just partial clone but need for full clone(except production)

  • Sylvain Lotteau
    Reply
    |
    May 31, 2021

    Hello Oto,

    Why would you like to keep the original reconstruction ? Is that "just in case" , or do you have specific workflows where you would like to keep the original reconstruction ?


    Thanks,

    Sylvain