ContextCapture and ContextCapture Center

When production is finished it is showing the "Processing time". The value is only showing the last session of the engine for that production - not the total processing time. Please change it to be "Total Processing Time".

Overlap Report after AT that shows the Longitude overlap (minimum 80%) and the Lateral overlap (minimum 50%). The user should have an estimation if the overlap meets the requirements - therefor if more photos should be added somewhere.

Add a feature to select an area and then make the surface to look blurry (for restricted area or to give focus to the point of interest in the model)

When adding images to a new block there is an option to modify between Sea Level or WGS 84 Ellipsoid. After modifying or not there is no place that it is stated what was selected. We wish to know what was selected in each block.

From a user stand point, there is way less information in the production general view, which creates a lack of visibility The milestones are only greyed out or 'complete' when the tile is fully produced. It was very useful to see which tile was be...

Propose ECW as an output format for orthophotos

Add E57 vendor-neutral format export support. Now to generate E57 needs to produce LAS which requires additional storage and possible loss of information if need to have E57 as result. Also have to use 3rd party software.

Simple option, allowing user to create a new block out of the rejected photos in the AT.

When using the potential matches window to mark GCPs, it would be nice if the next image in the sequence - either by distance or name - would be pre loaded into the main window for selection, rather than the user having to select the next image fr...

When importing LiDAR data over photo tie points I'd like to see how close they lay on top of one another. A cross section viewer would be helpful.