User always works in same coordinate system. Would it be possible to set custom default settings. When creating a project these settings could be used.
Indication if control points is a check point - Survey
Could we have a visual indication of which points are check points? It’s incredibly tedious to have to either hover over a point, edit it or open up the report page simply to see which ones are checks and which are being used as control points. (A...
Warning message when doing an AT on a very large point cloud
If the user wants to do an AT adjusted on a point cloud, this one will fail (after a substantial time) if one of the point cloud is bigger than approx. 130Mpoints for a 64GB machine.It would be helpfull to have a warning at the beginning of the AT...
Incremental engine. Make it possible to add images to add to triangulation based on selection.
At this moment we need to add images to use the incremental engine, but it would be usefull if this can be selected from a part of the images that where rejected.
Setting the .las Scale based on resolution is ok until you land a project that has three levels of UAV imagery, some terrestrial Lidar, and some Ground based imagery. The resulting las tiles had scales from 0.1 to 0.001, we only needed a scale ...
In the GCP pannel, for potential matches, prioritize the photo order with the expected GCP location being the closest to the center of the photos
When selecting the ground control points, target that are centered in the photos are usually better defined and it make sense to prioritize those measurements.
Orthophoto/DSM, images shall contains pyramids to offer a better loading in Descartes/CCE/MS
There is no pyramid in the picture. Pyramids are lower resolution copies of the image (the equivalent of the caches that Raster Manager creates). it should contain an option that allows the user to create Geotiffs that contain the pyramids. In thi...